Dryer vents in North Carolina homes are covered by Section M1502 of the 2018 North Carolina Residential Code. When we repair, replace or install a vent, these are the rules we build to:
- Metal duct only. The duct run must be smooth-wall metal at least 0.0157 inch thick (No. 28 gage steel or No. 26 aluminum), 4 inches in diameter. Flexible duct is not allowed in the run.
- A listed transition duct. The connector between the dryer and the wall must be a single length listed to UL 2158A, no more than 8 feet long, and it cannot be hidden inside a wall, floor or ceiling.
- A length limit. The run can be up to 35 feet from the transition connection to the outside, minus allowances for every elbow (5 feet for a 4-inch radius 90-degree elbow, 2 feet 6 inches for a 45). The dryer manufacturer's instructions can set a different limit.
- Sealed joints, no screws inside. Joints are fastened and sealed, each section inserted in the direction of airflow, and no screws can stick into the duct where they catch lint.
- Proper support. The duct is supported at intervals of 12 feet or less.
- The right outside hood. The vent ends outside the house, at least 12 inches above the ground, with a backdraft damper and no screen.
Fire data shows why this matters. The U.S. Fire Administration found that failure to clean, at 34 percent, was the leading factor in residential clothes dryer fires. A crushed, sagging or too-long vent fills with lint faster, so it needs cleaning more often and is more likely to be missed.
We start every repair by inspecting the full run, from the dryer to the outside hood. You get a written price before any work begins, and photos of what we found and what we fixed.